![]() Right click on virtual machine and select GUEST > Install/Upgrade VMware Tools.From then on follow the on screen instructions till you get to the desktop.Choose "Custom: Install Windows only (advanced).".Accept the terms and click the "Next" button.Type Format Quick FS=NTFS, press Enter.Type Create Partition Primary Align=4096, press Enter.Type Select Disk # (where # is the number your drive shows up as), press Enter.At the command prompt, type Diskpart, press Enter.After booting you see the Install Windows 7 screen, press Shift + F10 to open a command prompt.Boot from your Windows 7 installation media.(without System Reserve Partition and with 4k alignment) Under ADVANCED, I/O Device Configuration: disable all Serial, and Parallel ports, as well as Floppy Controller.Keyboard Features: change Numlock to ON.Under MAIN, Legacy Diskette A: change to Disabled.Power on virtual machine and open Console – virtual machine should be loaded into BIOS.Go to Boot Options and check "The next time the virtual machien boots, force entry into the BIOS setup screen.Click on OPTIONS tab and then General, UN-Check "Enable logging".Ensure Network Adapter type is VMXNET 3. ![]() (anything over 3GB is a waste in 32bit Windows)
0 Comments
Leave a Reply. |